HOW DERMATEND WORKS
SKIN MOLE REMOVAL AT HOME 100% GUARANTEED
Here is what to expect with Dermatend
Day 1-3
After applying DermaTend™ every night to the mole, a
scab should form in its place. This can happen overnight with just one
application but normally takes about 3 days.
Day 3-10
Scab should begin to heal and dry up and will fall off. Make sure to
take care of the scab as removing it prematurely can increase total
healing time.
Day 10+
The scab should be gone leaving you with fresh new healthy skin. The
skin may still be healing and pink so take care of it, and it will
eventually leave no trace something was ever there.
DermaTend™ is made from a special blend of all natural ingredients combined to work with your body and your immune system to permanently dissolve skin moles and promote the growth of new, healthy skin tissue. DermaTend™ is the most complete formula and the only answer to safe, natural mole removal at home
APPLICATION: You will need a few supplies for preparing
the mole.
Emery board or toothpick (provided)
Cloth-based band-aid. ( 2 provided)
Vaseline
Q-tips helpful but not necessary
Clean wash cloth and soap
PREPARING YOUR BLEMISH FOR REMOVAL
Step #1 - Scratch or rub the ENTIRE blemish with toothpick or emery board provided. Be sure to avoid the surrounding skin. Scratching should be hard enough to allow DermaTend™ to penetrate the blemish yet not so hard that it bleeds. Scratching is the most important part!
Step #2 - Using a wash cloth with soap and hot water; cleanse the area using hot enough water to open up the pores.
Step#3 – Dry the area fully. Any remaining water will not allow DermaTend™ to penetrate.
Step #4 – Apply Vaseline to surrounding skin making sure to avoid the mole. This will protect the surrounding skin from redness in the case that it was accidentally scratched during preparation. Vaseline on the blemish will stop DermaTend™ from penetrating so please apply carefully.
Step #5 – Wash and dry hands.
REMOVAL STEPS - DAY 1
Step #1 – Gently massage DermaTend™ Tube before opening. If the tube feels too tight, unscrew cap, remove the ENTIRE silver protective seal, push out some air, recap, and continue to massage.
Step #2 - Apply DermaTend™ to the entire surface of the blemish using your fingertip. Use only enough DermaTend™ to cover the affected area; a little goes a long way. (Avoid getting DermaTend™ on the surrounding skin).
Step #3 - Cover with the fiber bandage and leave on for 24 hours. There MUST be a tingling sensation on the blemish usually lasting 5-10 minutes. (If you do not feel any tingling, you have not scratched enough and DermaTend™ may not be working at its maximum efficiancy).
After 24 hours:
Step #1 – Carefully remove the bandage.
Step#2 – Carefully clean DermaTend™ from the blemish
with water.
Step#3 – Carefully dab the area dry with towel.
If the blemish has turned into a scab:
Once the blemish has scabbed, you will NOT need to apply
any more DermaTend™. If you purchased the healing balm,
carefully apply this to the blemish and surrounding skin
several times daily. Keep covered with fiber bandage until
scab falls off naturally.
If the blemish has NOT formed a scab:
Repeat all blemish preparation steps as well as all removal
steps from day 1. Continue daily until the blemish forms a
scab.
ADDITIONAL NOTES
DermaTend™ works on flat moles as well as all raised moles.
Certain types of Moles are very hard and stubborn. Be patient and give DermaTend™ time to fully absorb. Know that the process can take 3 to 6 weeks with very stubborn cases. Don’t increase the amount you put on a stubborn blemish. Always use just enough to cover the mole.
DermaTend™ can cause redness and inflammation at the base of the growth. This is normal and will fade.
Be careful not to remove scab prematurely! Be sure to allow the scab to heal on its own (Up to 7 – 10 Days). This will lessen your chance of scarring. We recommend keeping the scab covered with a bandage to prevent it from coming off early.
DermaTend™ should be a thick, gritty, brown paste. It does not absorb into the blemish; rather it coats it. If you notice your DermaTend™ is watery, gently massage the tube to mix the ingredients.
